Necta Rondo - GSM Alerts and Pre-Alarm Configuration

P2125EN00
01 - 2008

34
6
gsm
The control software can send, via GSM modem, a signal indicating
a machine failure or an “ending product” “pre-alarm”, after dis-
pensing a certain (programmable) number of selections of a given
product.
6.1
gsm P
I n c o d e
This function is used for programming the identication code that
will be sent to the GSM modem (optional) when switching the ma-
chine on.
6.2
gsm
P r e -a l a r m s
6.2.1
Pr e -a l a r m s t h r e s h o l d s
This function is used for dening the number of pieces of a given
product after which an “ending product” pre-alarm is signalled via
modem.
6.2.2
r
e s e t t I n g t h e P r e -a l a r m c o u n t e r s
With this function the counters that control the pre-alarms are reset.
6.2.3
t
h r e s h o l d a s s o c I a t I o n
This function is used for dening which spirals/selections to associ-
ate to pre-alarms for “ending product”.
6 - GSM
6.1 - GSM PiN CODE
6.2 - GSM PRE-ALARMS
6.2.1 - PRE-ALARM THRES.
6.2.2 - RESET PRE-AL.CNT
6.2.3 - SEL. COMbiNATiON
6.3
ba n k n u m b e r
The number in the bank of machines (1 to 7) that identies the
machines that have the “slave GSM” function, therefore sending
data via the “master” machine modem .
The number 0 identies the machine that is connected directly to
the modem, i.e. the “master GSM”.
6.3 - GROUP NUMbER