P2125EN00
01 - 2008
17
2.2 - SPiRAL/SELECT.
2.2.1 - SPiR. PARAMETERS
2.2.1.1 - MACHiNE CONfiG.
2.2.1.2 - ViRTUAL SELECT.
2.2.1.3 - ViRT. PRiCE RET.
2.2.1.4 - TWO-MOTOR SELECT
2.2
sP I r a l s /s e l e c t I o n s
2.2.1
sP I r a l P a r a m e t e r s
2.2.1.1
ma c h I n e c o n f I g u r a t I o n
This function is used to detect and store the number and position of
the trays and of the selection motors.
2.2.1.2
v
I r t u a l s e l e c t I o n s
This function is used to dene a pair of selections that can be sold
at a price dierent from the sum of the two selections, using a single
selection number.
10 virtual selections can be programmed (70 to 79).
2.2.1.3
r
e t u r n o f v I r t u a l P r I c e
This function is used to dene, in the event of failed second dis-
pensing in a virtual selection, not to cash the price of the second
selection (only if an MDB payment system or validator are used).
With other payment systems, it can be decided whether or not
return the entire amount.
2.2.1.4
t
w o -m o t o r s e l e c t I o n s
In order to dispense long shaped products, dividers can be tted so
that two motors/spirals can be used for each single selection.
With this function the simultaneous operation of two motors can be
combined, specifying the selection number of the second motor.
The rst motor number will be the selection number, while the selec-
tion number of the associated motor will remain disabled.
2.2.1.5 - ROTATiON SELECT.
2.2.1.5
ro t a t I o n s e l e c t I o n s
With this function it is possible to create 6 groups of spirals with the
same selection number that are activated by rotation, to increase
the autonomy of the same product and make dispensing uniform.
The grouped spirals of a single selection must be next to each other.
All selections belonging to the same group must have the same
price.
For correct safety management of the selections it is advisable that
also a dispensing detection device (photocells) be installed in the
machine.
To Next Page
Loading...
