Necta Rondo - Vending Machine Data and Initialization

P2125EN00
01 - 2008

31
5 - MiSCELLANEOUS
5.1 - VEND.MACH. DATA
5
mI s c e l l a n e o u s
5.1
ve n d I n g m a c h I n e I n f o r m a t I o n
5.1.1 - iNSTALLAT. DATE
5.1.2 - PRG. MACHiNE CODE
5.1.3 - OPER. CODE ENTRY
5.1.1
In s t a l l a t I o n d a t e
This function is used for storing the current date of system as instal-
lation date of the vending machine. This date will be indicated on the
statistics printout.
5.1.2
s
e t t I n g t h e m a c h I n e c o d e
This function is used for changing the 8-digit numeric code identify-
ing the machine (set to 0 by default).
5.1.3
s
e t t I n g t h e o P e r a t o r c o d e
This function is used for changing the 6-digit numeric code identify-
ing the group of machines (set to 0 by default).
5.2
I
n I tI a lI s In g t h e d a t a -b a s e
This function is used for “initialising” the machine, resetting all data
to default values. This function should be used if there is a memory
data error or when the software is replaced. Except for the general
electronic counter, all statistical data is reset.
When conrming this function some parameter settings are request-
ed, and namely:

Intended as type of base conguration for the dierent selections.
The available “countries” vary according to the models.

Intended as reference language for the strings shown on the display
in “normal vending” and “programming” mode.
5.2 - iNiTiALiSiNG Db