Necta Rondo - Coin Mechanisms; Immediate Change; Decimal Point

P2125EN00
01 - 2008

15
2.1.2 - COiN MECHANiSMS
2.1.2.1 - COiN MECHAN.SET.
2.1.2.2 - CHANGE iMMEDiAT.
2.1.3 - DECiMAL POiNT
2.1.2
co I n m e c h a n I s m s
2.1.2.1
se t t I n g t h e c o I n m e c h a n I s m s
It is possible to decide which of the payment system protocols avail-
able are to be enabled for the functions.
The available payment systems are:
- Executive
- Validators
- BDV
- MDB
-

2.1.2.2
I
m m e d I a t e c h a n g e
This function is valid only in the case where a change-giver coin
mechanism is installed in the machine.
Normally the amount for a selection is cashed after the machine
sends the message “Selection successful”, consequently the
change is returned at the end of dispensing the selected product.
By enabling this function, disabled by default, the cashed signal is
sent at the beginning of dispensing, consequently the change owed
to the user is returned at the same time of dispensing the product.
2.1.3
d
e c I m a l P o I n t
Press the conrm key “

” to display the position of the decimal
point, i.e.:
0 decimal point disabled
1 XXX.X
2 XX.XX
3 X.XXX
Press the conrm key “

”, these values will start blinking and can
then be modied as necessary.