P2125EN00
01 - 2008
This function is used for setting the number of coins (0 to 15) to determine the status of full change tubes and
the “Insert exact amount” message for the user.
It is possible to dene which, among the bills recognised by the reader, are to be accepted.
Check the reader conguration for the correct bill to value matching.
It is possible to dene which, among the coins recognised by the coin mechanism, are to be accepted when
the machine is in the “exact amount” condition.
Check the coin mechanism conguration for the correct coin to value matching.
It is possible to dene which, among the bills recognised by the accepter, are to be accepted when the ma-
chine is in the “exact amount” condition.
Check the accepter’s conguration for the correct bill to value matching.
This function is used for showing or not on the display the credit present in the cashless system, replacing it
with the string “-----”. The same string is displayed also in the event where the credit of the cashless system is
not dened.
Thus function is used for setting the management of credit excess.
Credit excess is a credit that cannot be returned to the user; for example in the event of failing to return the
change due to insucient minimum level in the tubes.
If set as MAINTAINED any credit excess remains available to the user.
If set as CANCELLED, it permits to maintain the credit excess for a programmable time before cashing it.
This function is used for setting the management of messages for sales made with cash for statistical
purposes.
0 - The data is sent as per MDB protocol
1 - The sales data is sent by overriding to the cashless system 1
2 - The sales data is sent by overriding to the cashless system 2
This function permits the use of a coin or bill validator in place of an MDB Changer (coins) or MDB Bill
Validator (banknotes).
The replaced MDB device, after resetting the machine, will no longer be used.
This value denes the combination of empty coin tubes, setting the coin mechanism in “exact amount” mode.
The possible combinations of empty coin tubes are indicated below.
For greater simplicity, the combination is described with reference to tubes A, B and C, where tube A receives
the lower value coins and tube C the greater value coins.
0 = A or (B and C)
1 = A and B and C
2 = A and B only
3 = A and (B or C)
4 = A only
5 = A or B only (default)
6 = A or B or C
7 = A or B only
8 = A or C only
9 = B and C only
10 = B only
11 = B or C only
12 = C only
co I n me c h a n I s m se t t I n g s
38
To Next Page
Loading...
