P2125EN00
01 - 2008
22
2.4.4 - CUSTOMiZ.STRiNGS
2.4.4.1 - ENAb. CUSTOM.STR
2.4.4.2 - PRG. CUSTOM.STR.
2.4.4
cu s t o m I z e d s t r I n g s
2.4.4.1
en a b l I n g t h e c u s t o m I z e d s t r I n g s
The machine uses standard messages to give information to the
user during normal operation (e.g. “Ready”, “Take” etc.).
By enabling this function it is possible to change these messages
as necessary. Changes are stored as copies of the standard
messages.
Therefore, if this function is disabled, the standard messages will be
displayed again, but the changed messages are still stored.
2.4.4.2
P
r o g r a m m I n g t h e c u s t o m I z e d s t r I n g s
With this function it is possible to change the messages; by press-
ing the conrm button “” the rst character starts blinking; this can
then be changed using the “” and “” buttons, scrolling through
the available characters.
Once the message is completed, it can be stored by pressing button
“”.
2.4.5 - COUNTER AT START
2.4.6 - CONTRAST CONTROL
2.4.5
co u n t e r a t P o w e r -o n
With this function it is possible to enable/disable the display of the
total number of sales since the last statistic reset, during the start-up
phase of the machine.
2.4.6
c
o n t r a s t c o n t r o l
This function is used for adjusting the electronic display contrast
between 5% and 99% (default).
To Next Page
Loading...
