P2125EN00
01 - 2008
In t r o d u c t I o n
This “Programming Manual” is a very useful tool for those operators who want to get the most out of the poten-
tial of the installed software and know in detail all of the available software functions.
This document is available in PDF format in the Reserved Area of our internet site
www.nwglobalvending.com or, on request, through our after-sales service.
The Manual is divided into 3 parts:
The First Part regards Normal Vending Mode; it describes the operations to be carried out during the vending
machine normal use:
- Power-on
- Messages for the user.
The Second Part descries the Filler Menu, the programming part that is used for changing individually the
sales prices of the selections and for simple controls on the functioning and on the machine sales.
The Third Part describes the Technician Menu, the programming part that is meant for technical personnel,
used for changing the machine performance.
The operations described can modify the functioning cycles, therefore they must be carried out only by per-
sonnel who have the specic knowledge of the machine functioning from a point of view of electrical safety
and health regulations.
The appendix contains the List of Failures, which describes the possible error signals and the self-diagnosis
conditions of the machine; it also describes the functions concerning the coin mechanism communication
protocols.
no r m a l v e n d I n g m o d e
Po w e r -o n
When closing the payment system compartment door or energising the machine, the power-on process is
started and the display indicates the version number of the installed software.
The machine can be programmed for displaying, for a few second, the number of selections made.
After a few seconds the internal lighting lamp is switched on and the machine goes into normal operating
mode:
A
To Next Page
Loading...
Need help?
General
