Nellcor N-395 - Language Selection

WAmING: Do not use a sensor cable with the
N-395 monitor (other than the SCP-10 or MC-10 sensor
cable). Use of another sensor cable will have an adverse
effect on performance. Do not attach any cable that is
intended for computer use to the sensor port. Do not connect
any device other than
a Nellcor approved sensor to the sensor
connector.
6. Plug the sensor into the SCP- 10 or MC- 10 sensor cable, and
secure the sensor in place by lowering the plastic sensor lock
over
the sensor connector until it clicks into place (refer to
the SCP-
10 or MC- 10 directions for use).
7.
Plug the SCP-10 or MC-10 cabl'e into the sensor port located
on the front of
the N-395.
LANGUAGE SELECTION
The languages available for display on the screen are English,
French,
Gennan, Dutch, Portuguese, Spanish, and Italian. The
N-395 is shipped with
tlie factory default English language
displayed.
To select
tlie appropriate language after the unit is powered on:
press the SETUP
softkey
press the NEXT softkey
press the LANG softkey
Use the ADJUST UP and ADJUST DO
Buttons to
select
tlie desired language
Press
the EXIT button to return to the main menu.
Service personnel may set
tlie appropriate language as the power-
on default using the procedure described in the N-395 service
manual.