Nellcor N-395 - Adjustable Settings; Pulse Beep Volume; Alarm Volume; Alarm Silence Duration

SafSecsnds Display
Wlien the N-395 SatSeconds technology detects an SpOz value
outside the alarm limit, the
SatSeconds indicator begins to "fill"
clockwise. When the
SpOz value is within the set limits, the
SatSeconds indicator will empty counter-clockwise. As seconds
pass and are compared against the alarm-limit and the
SatSeconds setting, the graph fills or empties proportionately.
The
SatSeconds circular graph is located on the right side of the
display, adjacent to the
Sp02 reading in the pleth view and at the
far left of the display in the blip view.
Wlien the graph is completely filled, indicating that the selected
SatSeconds liinit has been reached, an audible alarm sounds and
the displayed
%SpOz value flashes. As with traditional alarm
management, the audible alarm may be silenced by pressing the
ALARM SILENCE
button. -
ADJUSTABLE SETTINGS
The following adjustments can be made using the Adjust
UpIDowii and ALARM SILENCE Buttons.
a Pulse beep volume
Alarm
volume
Alarm silence duration
Disabling audible alarms
Pulse Beep Volume
To adjust the pulse beep volume during normal monitoring,
press and hold the ADJUST UP or ADJUST
DOWN Button to
change the setting. Pressing and holding the ADJUST DOWN
Button will cause the volume to decrease until it is no longer
heard.