options Description
Send Support Data To AIQ
Controls the flow of support and monitoring data from
VMware vCenter to NetApp SolidFire Active IQ.
Options are the following:
• Enabled: All vCenter alarms, NetApp HCI storage
alarms, and support data are sent to NetApp
SolidFire Active IQ. This enables NetApp to
proactively support and monitor the NetApp HCI
installation, so that possible problems can be
detected and resolved before affecting the
system.
• Disabled: No vCenter alarms, NetApp HCI
storage alarms, or support data are sent to
NetApp SolidFire Active IQ.
If you turned off the Send data to
AIQ option using NetApp
Deployment Engine, you need to
enable telemetry again using the
management node REST API to
configure the service from this
page.
Send Compute Node Data To AIQ Controls the flow of support and monitoring data from
the compute nodes to NetApp SolidFire Active IQ.
Options are the following:
• Enabled: Support and monitoring data about the
compute nodes is transmitted to NetApp SolidFire
Active IQ to enable proactive support for the
compute node hardware.
• Disabled: Support and monitoring data about the
compute nodes is not transmitted to NetApp
SolidFire Active IQ.
If you turned off the Send data to
AIQ option using NetApp
Deployment Engine, you need to
enable telemetry again using the
management node REST API to
configure the service from this
page.
Find more Information
• NetApp Element Plug-in for vCenter Server
To Next Page
Loading...
Need help?
General
