EasyManua.ls Logo

NetApp HCI - Install H-Series Hardware

NetApp HCI
363 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Steps
1. Open a web browser and browse to the IP address of the management node. For example:
https://<ManagementNodeIP>
2. Log in to NetApp Hybrid Cloud Control by providing the NetApp HCI storage cluster administrator
credentials.
The NetApp Hybrid Cloud Control interface appears.
Find more information
• NetApp HCI Resources page
• NetApp HCI Installation and Setup Instructions
• TR-4820: NetApp HCI Networking Quick Planning Guide
• NetApp Element Plug-in for vCenter Server Guide
• NetApp Configuration Advisor 5.8.1 or later network validation tool
• NetApp SolidFire Active IQ Documentation
Install H-series hardware
Before you get started with using NetApp HCI, you should install the storage and
compute nodes correctly.
See the poster for a visual representation of the instructions.
• Workflow diagrams
• Prepare for installation
• Install the rails
• Install the node/chassis
• Install the switches
• Cable the nodes
• Power on the nodes
• Configure NetApp HCI
• Perform post-configuration tasks
Workflow diagrams
The workflow diagrams here provide a high-level overview of the installation steps. The steps vary slightly
depending on the H-series model.
• H410C and H410S
• H610C and H615C
• [H610S]

Table of Contents