NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Basic Virtual Private Networking 6-31
v1.0, October 2005
c. Type ping -t 192.168.3.1 and then click OK.
This will cause a continuous ping to be sent to the first FVG318. Within two minutes, the
ping response should change from “timed out” to “reply.”
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote FVG318. After a short wait, you should see the login screen of the
Wireless VPN Firewall (unless another PC already has the FVG318 management interface
open).
• Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the FVG318.
a. Open a command prompt (Start -> Run -> cmd).
Figure 6-34
Note: Use Ctrl-C to stop the pinging.
Figure 6-35