NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
6-6 Basic Virtual Private Networking
v1.0, October 2005
• “Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page 6-10
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVG318
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
Figure 6-3
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 6-1 on page 6-4. If you have special requirements
not covered by these VPNC-recommended parameters, refer to Chapter 7,
“Advanced Virtual Private Networking” to set up the VPN tunnel.
192.168.3.1
VPN Tunnel
FVS318v3
24.0.0.1
PC
(Running NETGEAR
ProSafe VPN Client)
PCs