VPN Configuration of NETGEAR FVG318 C-1
v1.0, October 2005
Appendix C
VPN Configuration of NETGEAR FVG318
This is a case study on how to configure a secure IPSec VPN tunnel on a NETGEAR FVG318.
This case study follows the VPN Consortium interoperability profile guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html).
This study covers the following situations:
• FVG318 to FVG318 (see page B-6)
• FVG318 to VPN Client (see page B-15)
Case Study Overview
The procedure for configuring a VPN tunnel between two gateway endpoints is as follows:
1. Gather the network information
2. Configure gateway A
3. Configure gateway B
4. Activate the VPN tunnel
Note: Product updates are available on the NETGEAR, Inc. Web site at
http://www.netgear.com/support/main.asp.
To Next Page
Loading...
