NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
8-8 Maintenance
v1.0, October 2005
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the reset button on the rear panel of the firewall. See “Restoring the Default
Configuration and Password” on page 10-7.
Changing the Administrator Password
The default password for the firewall’s Web Configuration Manager is password. NETGEAR
recommends that you change this password to a more secure password.
From the main menu of the browser interface, under the Maintenance heading, select Set Password
to bring up this menu.
To change the password, first enter the old password, and then enter the new password twice. Click
Apply. To change the login idle timeout, change the number of minutes and click Apply.
Figure 8-7