Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Advanced Configuration 9-3
v1.0, October 2005
Using the LAN IP Setup Options
The LAN IP Setup menu allows configuration of LAN IP services such as DHCP and RIP. From
the main menu of the browser interface, under Advanced, click on LAN Setup to view the menu
shown below.
Configuring LAN TCP/IP Setup Parameters
The firewall is shipped preconfigured to use private IP addresses on the LAN side, and to act as a
DHCP server. The firewall’s default LAN IP configuration is:
• LAN IP addresses — 192.168.1.1
• Subnet mask — 255.255.255.0
These addresses are part of the IETF-designated private address range for use in private networks,
and should be suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in this menu.
Figure 9-1
To Next Page
Loading...
