NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
C-16 VPN Configuration of NETGEAR FVG318
v1.0, October 2005
Configuring the VPN Tunnel
The figure below shows LAN to PC VPN access from an FVG318 to a VPN Client.
Use this scenario illustration and configuration screens as a model to build your configuration.
1. Log in to the FVG318 labeled Gateway A as in the illustration above.
Log in at the default address of http://192.168.1.1 with the default user name of admin and
default password of password (or using whatever password and LAN address you have
chosen).
2. Use the VPN Wizard to configure the FVG318 at Gateway A.
Follow the steps illustrated in Figure B-11 (the resulting parameter screens are shown in
Figure B-12 on page B-17):
• Connection Name: Scenario_1 (in this example)
Note: This scenario assumes all ports are open on the FVG318.
Figure B-11
Note: Based on the network addresses used in this example, you would log in to the
LAN IP address of http://10.5.6.1 at Gateway A.
Gateway A
14.15.16.17
10.5.6.0/24
10.5.6.1
WAN IP
WAN IP
LAN IP
Client B
0.0.0.0
Router
Scenario 1
PC
(running NETGEAR
ProSafe VPN Client)