NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
VPN Configuration of NETGEAR FVG318 C-5
v1.0, October 2005
Activating the VPN Tunnel
You can activate the VPN tunnel by testing connectivity and viewing the VPN tunnel status
information as described in the following flowchart:
All traffic from the range of LAN IP addresses specified on the router at Gateway A and the router
at Gateway B will now flow over a secure VPN tunnel.
Note: The default log in address for the FVG318 router is http://192.168.1.1 with
the default user name of admin and default password of password. The
login address will change to the local LAN IP subnet address after you
configure the router. The user name and password will also change to the
ones you have chosen to use in your installation.
Figure B-4
Test Step 1
Ping Remote
LAN IP Address
Test Step 2
Ping Remote
WAN IP Address
Test Step 3
View VPN
Tunnel Status
Start
Fix the
Router Network
Fix the
VPN Tunnel
End
Fail Pass
Fail Pass
and then Retest and then Retest