NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
8-2 Maintenance
v1.0, October 2005
This screen shows the following parameters:
Click Connection Status to display the WAN connection status.
Table 8-1. FVG318 Status fields
Field Description
System Name The System Name assigned to the firewall.
Firmware Version The firewall firmware version.
WAN Port These parameters apply to the Internet (WAN) port of the firewall.
MAC Address The MAC address used by the Internet (WAN) port of the firewall.
IP Address The IP address used by the Internet (WAN) port of the firewall. If no address is
shown, the firewall cannot connect to the Internet.
IP Subnet Mask The IP Subnet Mask being used by the Internet (WAN) port of the firewall.
DHCP The protocol on the WAN port used to obtain the WAN IP address. This field can
show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to Client,
the firewall is configured to obtain an IP address dynamically from the ISP.
LAN Port These parameters apply to the Local (WAN) port of the firewall.
MAC Address The MAC address used by the LAN port of the firewall.
IP Address The IP address used by the Local (LAN) port of the firewall. The default is
192.168.1.1
IP Subnet Mask The IP Subnet Mask used by the Local (LAN) port of the firewall. The default is
255.255.255.0
DHCP Identifies if the firewall’s built-in DHCP server is active for the LAN attached
devices.
Figure 8-2