NETGEAR ProSafe FVG318

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
VPN Configuration of NETGEAR FVG318 C-19
v1.0, October 2005
a. Right-mouse-click the ProSafe icon ( ) in the system tray and select the Security Policy
Editor. If you need to install the NETGEAR ProSafe VPN Client on your PC, consult the
documentation that came with your software.
b. Add a new connection using the Edit/Add/Connection menu and rename it Scenario_1.
(Scenario_1 is used in this example to reflect the fact that the connection uses the Pre-
Shared Key security scheme and encryption parameters proposed by the VPN
Consortium, but you may want to choose a name for your connection that is meaningful to
your specific installation. The name you choose does not have to match the name used at
the gateway end of the VPN tunnel.)
c. Program the Scenario_1 connection screen as follows (see Figure B-15 on page B-20):
• Connection Security: Secure
• Remote Party Identity and Addressing: Select IP Subnet from the ID Type menu and
then enter 10.5.6.1 for Subnet, 255.255.255.0 for Mask, and leave All for Protocol.
(The Subnet and Mask parameters entered here must match the Start IP address and
Subnet Mask parameters of the Local IP Traffic Selector on the VPN Autopolicy
screen shown in Figure B-13 for the gateway router.)
• Enable Connect Using Secure Gateway Tunnel; select Domain Name for ID_Type;
enter fvs_local for Domain Name; and enter 14.15.16.17 for Gateway IP Address.
(Domain Name must match the Local Identity Data parameter of the IKE Policy
Configuration screen shown in Figure B-13 for the gateway router. Also, Gateway
IP Address must match the WAN IP address of the gateway router shown in
Figure B-11.)
Figure B-14