Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
C-24 VPN Configuration of NETGEAR FVG318
v1.0, October 2005
At this point the VPN-tunnel-endpoint-to-VPN-tunnel-endpoint connection is established.
2. Test 2: Ping Remote WAN IP Address (if Test 1 fails): To test connectivity between the
Gateway A and Gateway B WAN ports, follow these steps:
a. From a Windows Client PC, click the Start button on the taskbar and then click Run.
b. Type ping -t 14.151.6.17, and then click OK.
c. This causes a ping to be sent to the WAN interface of Gateway A. Within two minutes, the
ping response should change from timed out to reply. You may have to run this test several
times before you get the reply message back from the target FVG318.
d. At this point the gateway-to-gateway connection is verified.
3. Test 3: View VPN Tunnel Status: To view the FVG318 event log and status of Security
Associations, go to the FVG318 main menu VPN section and click the VPN Status link. For
the For the VPN Client, click VPN Status on the VPN Status/Log screen.
a. Open the popup menu by right-clicking on the system tray icon.
b. Select Connection Monitor.
See Figure B-20 below for the resulting status screens.
Figure B-19
To Next Page
Loading...
