Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Connecting the Firewall to the Internet 3-5
v1.0, October 2005
If you cannot connect to the wireless VPN firewall, verify your computer networking setup. It
should be set to obtain both IP and DNS server addresses automatically, which is usually so.
For help with this, see “Preparing a Computer for Network Access:” in Appendix A or the
animated tutorials on the Resource CD.
2. Click OK. Follow the prompts to proceed with the Smart Wizard Configuration Assistant to
connect to the Internet.
3. Click Done to finish. If you have trouble connecting to the Internet, see “Troubleshooting
Tips” on page 3-6 to correct basic problems.
Figure 3-5
Note: If you do not see this page, type http://www.routerlogin.net in the browser
address bar and press Enter. If you still cannot see this screen, see “How to
Bypass the Configuration Assistant” on page 3-10.
To Next Page
Loading...
