NETGEAR WGU624 User Manual

Reference Manual for the Double 108 Mbps Wireless Firewall Router WGU624
4-4 Wireless Configuration
M-10153-01
Default Basic Wireless Settings
When you first receive your WGU624, the default factory settings in effect are shown in the table
below. You can restore these defaults with the factory default reset button on the rear panel.
Table 4-2. Default Wireless Settings
After you install the WGU624 wireless router, use the procedures below to customize any of the
settings to better meet your networking needs.
Basic 802.11a Wireless Settings
To configure the 802.11a wireless settings of your router, click the Wireless a link in the main
menu of the browser interface. The Wireless 802.11a Settings menu appears, as shown in
“Wireless 802.11a Settings menu” on page 4-5.
FEATURE DEFAULT SETTINGS
Wireless Access Point Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR_11g for 802.11g
NETGEAR_11a for 802.11a
11b/g RF Channel 11
11a RF Channel 36
Mode g and b for 802.11g
a only for 802.11a
Authentication Type WPA-PSK
WPA-PSK passphrase NETGEAR-ULTRA-G

NETGEAR WGU624 Specifications

Power

power adapter voltage	5V
power adapter current	2.8 A

Networking and Connectivity

network standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11a
ports	Five10/100 (1 Internet, & 4 LAN) ports
operating frequencies	2.4 GHz and 5.0 GHz

Weight and Dimensions

dimensions	6.9 x 1.1 x 4.7 in (175.3 x 27.94 x 119.4 mm)
weight	.7 lbs (.3 kg)
max range (indoor)	400 ft