x
Specifications
Dimensions: 3.7 x 7.5 x 9.0 in. (94 x 191 x 229 mm )
Weight: 5 lb ( 2.3 kg )
Enclosure: Metal case, painted
Connectors: Calibration Module: 8-Pin Sub Mini DIN
Analog Output: BNC
RS-232: 9 pin D-Sub
GPIB: 24 Conductor D
Power : 100-120, 220-240 VAC ±10%, 50/60 Hz
Absolute Maximum Line
Current Rating: 200 mA
Signal Ranges: Up to 8 decades (dependent on detector type)
Display: 4.5 digit, annunciated, backlit, wide angle view LCD
Display Update Rate: 75 ms
Auto-Ranging Time: 200 ms (typical)
GPIB Bus Transfer Time: 10 ms (typical)
Operating Environment: 0 to +40 degree C; < 70% RH noncondensing
Storage Environment: −20 to +60 degree C; < 90% RH noncondensing
Compatible Detectors: Low-Power (Semiconductor) Family
Signal Range
1, 2
12345678
Full-Scale Current
3
2 nA 20 nA 200 nA 2 µA 20 µA 200 µA 2 mA 5 mA
Gain 1000 M 100 M 10 M 1 M 100 k 10 k 1 k 100
Resolution 0.1 pA 1 pA 10 pA 100 pA 1 nA 10 nA 100 nA 1 µA
Analog Bandwidth 35 Hz 35 Hz 1.5 kHz 1.5 kHz 5 kHz 15 kHz 10 kHz 20 kHz
Full-Scale Accuracy
4
0.2 % 0.2 % 0.2 % 0.2 % 0.2 % 0.2 % 0.2 % 0.2 %
(Typical)
Full-Scale Accuracy
4
0.4 % 0.4 % 0.4 % 0.4 % 0.4 % 0.4 % 0.4 % 0.4 %
(Worst Case)
1
Listed signal ranges specify meter capability. Available signal ranges are detector dependent.
2
Maximum measurable signal is detector dependent. See description of detector saturation message “SA” in Table 2.
3
Full scale current may vary due to the Auto-Calibration compensation of amplifier DC offsets.
4
After 60 minute warm-up, followed by execution of an Auto-Calibration. See Section 2.5 and Section 6.2 (“O” Command).
Analog Output
Full-Scale Voltage: 2V into 1MΩ
Full-Scale Accuracy: ±1%
Maximum AC Noise: Range 1: <4 mV
p-p
(open input) Ranges 2-8: <1 mV
p-p
To Next Page
Loading...
Need help?
General
