3
Section 2
Initial Setup
2.1 Introduction
This section contains information on how to configure the 1830-C to your
local line voltage and how to connect the detector and calibration module
to the meter. It also includes a short discussion about the remote interface
and the 1830-C’s power-up and auto-calibration.
2.2 Setting the Line Voltage Selector Switch
The 1830-C can be configured to operate with line voltages of 100-120 VAC
and 220-240 VAC, and line frequencies between 50-60 Hz. Before turning the
meter on, configure it to the local voltage by setting the voltage selection
switches on the 1830-C back panel to match the nominal local voltage. See
Figure 2. Plug the AC line power cord to the rear of the 1830-C and then
connect the cord to AC power.
LINE SELECT
230V
115V
PLACE ONLY WITH FUSE OF SPECIFIED RATING.
100–120V 50–60 Hz, 0.25A, SLO- BLO, 250V
220–240V 50–60 Hz, 0.25A, SLO- BLO, 250V
FUSE
Figure 2. Line Voltage Selection Switch
WARNING
This product is equipped with a 3 wire grounding type plug. Any
interruption of the grounding connection can create an electric shock
hazard. If you are unable to insert the plug into your wall plug recep-
tacle, contact your electrician to perform the necessary alterations to
assure that the green (green-yellow) wire is attached to earth ground.
To Next Page
Loading...
Need help?
General
