2
1.2 Scope of this Manual
Please carefully read this instruction manual before using the 1830-C. Be
especially careful to observe the warnings and cautions throughout this
manual (see Safety Symbols and Terms). If any operating instructions are
not clear, contact Newport Corporation.
This instruction manual contains the necessary information for operation
and maintenance of the 1830-C, as well as information for troubleshooting
and obtaining service if necessary. This information is divided into the
following sections:
Section 1 General Information
Section 2 Initial Setup
Section 3 System Operation
Section 4 Performing Measurements
Section 5 Computer Interfacing
Section 6 Remote Command Set
Section 7 Troubleshooting and Maintenance
Section 8 Factory Service
1.3 Unpacking and Inspection
All 1830-C meters are carefully assembled, tested and inspected before
shipment. Upon receiving this instrument, check for any obvious signs of
physical damage that might have occurred during shipment. Report any
such damage to the shipping agent immediately.
NOTE
Retain the original packing materials in case reshipment becomes necessary.
1.4 Preparation for Use
The 1830-C should have some basic operations performed before measure-
ments are made. These include:
Setting the Line Voltage Selector Switch ( Section 2.2)
Detector Connection and Setup ( Section 2.3)
To Next Page
Loading...
Need help?
General
