27
Section 6
Remote Command Set
6.1 Summary of Command/Query Set
The following commands and queries are case insensitive. No spaces are
allowed between the letter-command and the parameter or question mark
(?). Only one command/query allowed per bus transaction.
Command Description
A0 Attenuator off
A1 Attenuator on
A? Attenuator query ( returns: 0, 1 )
B0 Beep off
B1 Beep on
B? Beep query ( returns: 0, 1 )
C Clear Status Byte Register
D? Data Query
E0 Echo off
E1 Echo on
E? Echo query ( returns: 0, 1 )
F1 Filter S ( Slow )
F2 Filter M ( Medium )
F3 Filter F ( Fast )
F? Filter query ( returns : 1, 2, 3 )
G0 Hold
G1 Go
G? Go query ( returns: 0, 1)
K0 Keypad/Display backlight off
K1 Set the Keypad/Display Backlight to medium intensity
K2 Set the Keypad/Display Backlight to high intensity
K? Keypad/Display Backlight query ( returns: 0, 1, 2 )
L0 No local lockout
L1 Local lockout
L? Local lockout query ( returns: 0, 1 )
To Next Page
Loading...
Need help?
General
