4 Chapter 1 General Information
WARNING
The American National Safety Institute (ANSI) states that a
shock hazard exists when probes or sensors are exposed to
voltage levels greater then 42 VDC or 42V peak AC. Do not
exceed 42V between any portion of the Model 5600 (or any
attached detector or probe) and earth ground or a shock hazard
will result.
CAUTION
There are no serviceable parts inside the Model 5600. Work
performed by persons not authorized by Newport Corporation
may void the warranty. For instructions on obtaining warranty
repair or service please refer to Chapter 8 of this manual.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
