10 Chapter 2 System Operation
2.4.2 Main Screen
The system main screen is shown below, and is discussed in detail in section
3.5.2 and later. The screen is displayed after power on initialization, and its
displayed elements will depend on the mode of operation. In this example,
the unit is in constant current mode, displaying the current set point,
photodiode read back, and voltage read back.
→
→→
→
Io= 0.00 A <LDD>
Im= 0 uA
Vf= 0.000 V MOD
OutT SETUP
←
←←
←
Figure 2 - Main Screen
2.4.3 Menu Structure
The 5600 has a simple menu structure for changing the operation settings,
such as limits, communications parameters, and so forth. Each menu has
settings accessible by first pressing the
MENU
button, then using the soft
keys to navigate through the menus. When discussing the menu items within
a menu, all the items are shown in a single box.
NOTE
The 5600 display is a four line display, therefore only
four elements will be visible at a time.
2.4.3.1 Laser Setup Menu
The Laser Setup menu is covered in section 3.5.3, and covers settings that
pertain to the operation of the laser, such as mode, limits, bandwidth, pulse
mode, and so forth.
2.4.3.2 Modulation Setup Menu
The Modulation Setup menu is covered in section 3.5.4, and covers settings
that pertain to the modulation operating mode (off, internal, external) and the
internal modulator settings.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
