Newport 5600 Series - Tilt-Foot Adjustment; Rack Mounting; Ventilation Requirements; Power-Up Sequence

6 Chapter 2 System Operation
2.2.2 Tilt-Foot Adjustment
The 5600 has front legs that extend to make it easier to view the LCD
display. To use them, place the 5600 on a stable base and rotate the legs
downward until they lock into position.
2.2.3 Rack Mounting
The 5600 may be rack mounted by using a 5600 rack mount kit. All rack
mount accessory kits contain detailed mounting instructions.
2.2.4 Ventilation Requirements
Rear panel area needs 2 to 4 inches of clearance for air circulation.
2.2.5 Power-Up Sequence
With the 5600 connected to an AC power source, set the power switch to “
I
”
to supply power to the instrument and start the power-up sequence.
During the power-up sequence, the initialization screen is displayed. The
software version is displayed in the lower left corner of the screen. During
this time a self-test is performed to ensure that the 5600 hardware and
software are communicating. If the 5600 cannot successfully complete this
test, an error message will be displayed.
After this test, the 5600 is configured to the state it was in when the power
was last shut off and displays the main display.
2.2.6 Quick Start
After the power-on sequence is complete, the 5600 goes to the laser display.
To set up the laser driver, press the
MENU
button, then select laser setup. At
this point, the display shows all laser parameters. Using the cursor keys and
dial, select the desired functions and set the parameter values. When
finished, return to laser display by pressing the
MENU
button.
Enter the desired set point value using the cursor keys or the dial. Press the
LDD ON
button to operate the laser. The LED illuminates to indicate laser
operation. To turn the laser off, press the
LDD ON
button.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com