Chapter 2 System Operation 15
2.5.3 Modulation Input BNC Connector
The Modulation connector provides external modulation control. See section
3.3.
2.5.4 Current Monitor BNC Connector
This is the current monitor BNC.
2.5.5 Detector Input BNC Connector
The connector allows the connection of a BNC terminated detector.
2.5.6 LDD Output Connector
The LDD Output connector provides the laser connection. See section 3.3.
2.5.7 Input Power Connector
Accepts a standard line cord for AC input. Also selects one of four AC input
settings: 100V, 120V, 220V, and 240V. The cord must be removed to
change the setting. A small screwdriver will open the top of the module and
expose the rotary switch. Select the range that is closest to your expected
nominal RMS line voltage. The voltage selection is set for 120 VAC prior to
shipping.
CAUTION
Do not exceed 250 VAC on the line input.
Do not operate with a line voltage that is not within
±
10% of the line setting. Too low of an input voltage
may cause excessive ripple on the DC supplies. Too
high of an input voltage will cause excessive
heating.
2.5.8 GND Post
Provides access to chassis ground, which is also an earth ground as long as a
standard 3-wire line cord is used. This is a protective conductor terminal to
be used to achieve chassis grounding requirements when the main
connectors don’t provide an earth ground terminal. Use a minimum of 18
gauge wire to connect to this terminal.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
