65
CHAPTER 9
9.
Error Messages
9.1 Introduction
Error messages may appear on the display when error conditions occur in the
respective functions of the 5600.
In remote operation, the current error list can be read by issuing the "ERR?"
query. When this is done, a string will be returned containing all of the error
messages which are currently in the error message queue.
The errors codes are numerically divided into areas of operation as shown
below.
Error Code Range
Area of Operation
E-001 to E-099 Internal Program Errors
E-100 to E-199 Parser Errors
E-200 to E-299 Execution Control Errors
E-300 to E-399 GPIB/RS232 Errors
E-500 to E-599 Laser Control Errors
E-900 to E-999 System Errors
Table 3 contains all of the error messages that may be generated by the 5600.
Table 3 - Error Codes
Error Code Explanation
E-001 Memory allocation failure.
E-002 Floating point error
E-104 Numeric type not defined.
E-106 Digit expected.
E-107 Digit not expected.
E-115 Identifier not valid.
E-116 Parser syntax error, character was not expected.
E-126 Too few or too many program data elements.
E-201 Value out of range.
E-214 Length exceeds maximum.
E-217 Attempted to recall a bin from a unsaved position.
E-218 Additional link could not be added to the link
table because the link table is already full.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
