Newport 5600 Series - Page 77

66 Chapter 9 Error Messages
Error Code Explanation
E-301 A response message was ready, but controller
failed to read it.
E-302 5600 is talker, but controller didn't read entire
message.
E-303 Input buffer overflow
E-304 Output buffer overflow
E-305 Parser buffer overflow
E-501 Laser interlock disabled output.
E-502 Laser hard current limit disabled output
E-503 Laser open circuit disabled output.
E-504 Laser current limit disabled output.
E-505 Laser voltage limit disabled output.
E-506 Laser photodiode current limit disabled output
E-507 Laser photodiode power limit disabled output.
E-509 Laser short circuit disabled output
E-510 Laser out of tolerance disabled output.
E-512 Analog section status is all 1's or 0's (power
down).
E-514 Laser mode change disabled output
E-515 Laser bandwidth change disabled output
E-516 Incorrect Configuration for Calibration Sequence
to start.
E-517 Calibration for Laser Diode current must have the
output on to start.
E-518 Calibration for the Monitor Diode must have the
output on and the sensitivity set to zero to start.
E-531 Laser link condition forced output on
E-532 Laser link condition forced output off
E-533 Attempted to select non-laser channel for laser
operation.
E-900 Calculation Error shutdown output
E-901 System over temperature shutdown all outputs
E-902 Front laser enable panel key lock in off position,
shutdown all laser outputs
E-903 Loading of a saved bin shutdown driver output
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com