16 Chapter 2 System Operation
2.5.9 Trigger Input BNC Connector
Used for external trigger in pulse mode. It controls the rate.
2.5.10 Trigger Output BNC Connector
Used in pulse mode to sync. other devices.
2.5.11 Interlock/Detector Connector
Connections for interlock, detector and sensor. See section 3.3.
2.6 Warm Up and Environmental Consideration
Operate the 5600 at an ambient temperature in the range of 0 to +40
°
C.
Storage temperatures should be in the range of -20 to +60
°
C. To achieve
rated accuracy, let the 5600 warm up for 1 hour. For greatest accuracy,
recalibrate when ambient temperature changes more than a few degrees.
CAUTION
Operating above +40
°
C can cause excessive heating
and possible component failures.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
