Chapter 2 System Operation 11
2.4.3.3 Communications Menu
Err While Rmt= No
GPIB Address= 4
Speed= 9600 Baud
Terminal Mode= No
Figure 3 - Communications Menu
The Communications menu contains the setup parameters for GPIB and RS-
232C communications.
The
Local
soft button will return the 5600 to local mode after being
controlled over GPIB or RS-232C.
Error messages may appear on the display when error conditions occur
which force the output off or reflect hardware errors in the 5600. Display of
error messages on the 5600 screen may be disabled while in remote mode by
setting
Err While Rmt
to
No
. Errors will continue to accumulate in the
error queue, but will not be displayed on-screen.
GPIB Address
selects the device address on the GPIB bus. The allowed
range is 1 to 31.
Speed
controls the speed of the RS-232C interface. The allowed speeds are
300, 1200, 2400, 4800, 9600, 19200, and 38400. The parity is NONE, and
data bits are 8.
Terminal Mode
controls the system prompt when communicating over the
RS-232C interface. See the section on terminal mode in the
Computer
Interfacing
Manual
.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
