Chapter 2 System Operation 7
2.3 Introduction to the 5600 Front Panel
2.3.1 Model 5600
Described below are the functions of each area of the Model 5600 front
panel, as shown in Figure 1.
Figure 1 - Model 5600 Front Panel
1.
Power
/
Ο
ΟΟ
Ο
Switch
- Switches on (
) or off (
Ο
ΟΟ
Ο
) the AC power to the
unit.
2.
Remote LED
- Indicator will light to show when the unit is being
computer controlled. See section 2.4.3.3 for additional information on
remote mode.
3.
Laser Active LED
- Indicates laser output is on.
4.
LDD On Button
- Turns the laser output on/off.
5.
Cursor Control Keys
– The four cursor keys located below the
MASTER
button moves the cursor up or down between editable data
fields. The left arrow decrements values in numerical entry fields, or as a
previous choice in a multi-choice entry field. The right arrow increments
values in numerical entry fields, or as a next choice in multi-choice entry
fields. See section 2.4.1.3 for a description of data fields.
6.
MENU Key
- Switches to the menu from the main screen, or back to the
main screen from the menu (see section 2.4).
7.
Dial
– The large dial located to the right of the
LDD On
button is used
to continuously vary certain parameters. The dial has an acceleration
factor that causes the rate of change to increase as the dial is turned
faster. Turning slowly allows for a fine adjustment at the smallest
displayed decimal place.
8.
Keyswitch
- Laser safety keyswitch.
9.
Master Key
- switches to the master display from any screen in the
system.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
