58 USB-Link™ Installation and Setup Manual
Chapter 3 • Preparing to Use the USB-Link™
NOTE:
i The vehicle’s diagnostic connector is typically located under the dash-
board on the driver’s side, or beside the driver’s seat. It can also be
located in the engine compartment, near the electronic control unit (ECU).
At this point, the Power (green) LED on the USB-Link™ should be illumi-
nated (on).
—If the Power LED is not illuminated, turn the vehicle’s key to the ON posi-
tion, leaving the engine off.
When using a Bluetooth wireless connection, you will hear an alert signal when a
PC running an RP1210A compliant application connects and disconnects from the
USB-Link™.
In addition, when the USB-Link™ is out of range (more than 100 ft.) of the PC
while the application is running, the device will beep and the fault LED will flash
until the USB-Link™ is back in range. Plugging the USB cable into the USB-Link™
will silence the out-of-range beep and turn off the flashing fault LED.
Wired Connection Using a USB Cable
To connect the USB-Link™ to a desktop or notebook computer by means of a
USB cable:
1 Connect the USB cable to the USB port of the PC or laptop.
To Next Page
Loading...
