NEXIQ Technologies USB-Link - Bendix ABS Diagnostics; Caterpillar Electronic Technician

- Step 8: Setting Up Diagnostic PC Applications
USB-Link™ Installation and Setup Manual 69
The Allison Transmission screen appears.
2 Click
Connect to Vehicle.
The
Transmission Connect/Disconnect screen appears.
3 Click on the radio button (
) next to the Transmission Type field, then select
WTEC Series.
4 Click on the next to the Vendor field, then select NXULNK32.
5 Click on the next to the Protocol field, then select J1708.
6 Click on the next to the Device field, then select USB-Link J1708 if the con-
nection is wired; select BT USB-Link J1708 is the connection is wireless.
7 Click
Connect.
Bendix ABS Diagnostics
NOTE:
i Complete the steps in the following procedure before attempting to run this
application.
1 From the PC’s desktop, click Start then select Programs
4
ACOM Diag-
nostics NAD.
The
Diagnostic Interface Selection screen appears.
2 Under Available hardware interfaces: use the drop-down list box to select one
of the following:
—Select RP1210A device using J1708 line: BTUSBLINK (BT USB-Link
J1708) for wireless connection.
—Select RP1210A device using J1708 line: USBLINK (USB-Link J1708)
for wired operation.
3 Click OK.
Caterpillar Electronic Technician
1 From the PC’s desktop, click Start then select Programs
4
Caterpillar
ET
4
Electronic Technician.
2 Click on Utilities
4
Preferences on the screen’s menu bar.