Nice D-PRO AUTOMATIC NDCC1000 - Description of Electronic Circuit Board

EN
10 – English
L3 NL2L1
PE
V WU
BRAKE
13
6
4
8,2k
Opto
8,2k
Opto
8
TABLE 4 - Electronic circuit board
Tag Description
CHAIN
Removable connector for activating the
chain release.
If not in use, leave bridged
MOTOR
Removable connector for connecting the
motor.
For single-phase motors:
• U - common
• V – open
• W - close
HP FUSES
T type fuses F1, F2, F3; see chap. 7.
PRODUCT SPECIFICATIONS on p. 30
LINE
Removable connector for connecting the
control unit to the mains (three-phase and
single-phase)
PE
Terminals for earth connection
BRAKE
Removable connector for connecting a 200V
DC electromechanical brake
OUTPUT
Removable connector for relay outputs:
• Relay 1  pins 7-8-9 (P112)
• Relay 2  pins 4-5-6 (P111)
• Relay 3  pins 1-2-3 (P110)
STOP
Removable connector for connecting an
external emergency button.
If not in use, leave bridged
INPUT
Removable connector for programmable
inputs:
• UP input (P100)
• IMP input (P102)
• DOWN input (P101)
KEY
SWITCH
Connector for connecting a key selector
switch. If not in use, leave bridged
PHOTO
Removable connector for connecting
photocells
SAFETY
EDGE
Removable connector for connecting the
safety edge
• For optical safety edges move the
jumper between the central pin and the
OPTO marking
• For resistive or pneumatic safety edges
move the jumper between the central pin
and the 8k2 marking
1/2 UP
Connector for connecting the partial-
opening cam (can only be used with
mechanical limit switches)
Terminal for connecting an external aerial
RADIO
Moulded connector for connecting a
compatible Nice radio receiver
LOGIC
BOARD
Logic board for controlling the D-Pro
Automatic
ENCODER
(NU)
Removable connector for connecting an
electronic encoder (not used)
ENCODER
Mini-Fit connector for connecting an
electronic encoder
LIMIT
SWITCH
Removable connector for connecting a
mechanical encoder.
If an electronic limit switch is used, this
connector can be used as an input
programmable via parameter P103 (between
"COM" and "Pre-Lim").
LP FUSE
F type fuses F4; see chap. 7. PRODUCT
SPECIFICATIONS on p. 30
BOOST
Connector for inserting the "boost capac-
itor" board for single-phase motors.
When using three-phase motors or with
inverters, bridge the connector on the rst
two pins as shown in the diagram
2.6 Description of electronic circuit board
RADIO
CHAIN MOTOR LINE
PE
BRAKE
OUTPUT
PHOTO
1/2 UP
LOGIC BOARD
ENCODER (NU)
ENCODER
LIMIT SWITCH
LP FUSE
BOOST
SAFETY EDGE
STOP
INPUT
KEY
SWITCH
HP
FUSES
Resistive/Pneumatic
safety edge 8K2
Optical safety
edge (OSE)
SAFETY EDGE