EN
30 – English
6. DISPOSING OF THE PRODUCT
The adjacent symbol afxed to the product indicates that it is considered as WEEE.
The abbreviation WEEE (Waste Electrical and Electronic Equipment) indicates that this product:
-at the end of its useful life must not be assimilated with other household waste but must be disposed of separately;
-contains mixed recyclable and non-recyclable materials;
As such, if you have to dispose of the product, it must be “collected separately” in accordance with the regulations in force in your area.
Warning! – Some parts of the product may contain polluting or dangerous substances. If not disposed of correctly, these substances may have a
damaging effect on the environment and human health.
Warning! – Local regulations may impose heavy penalties if this product is not disposed of in compliance with the law.
Warning! As with the installation, only qualied personnel must dismantle the product at the end of its life.
7. PRODUCT SPECIFICATIONS
NOTES
• All of the technical specications given refer to a temperature of 20°C (± 5°C).
• Nice reserves the right to make such changes to the product as are deemed necessary while maintaining its functionality and intended use.
• The complete use manual consists of the use instructions for the automation and the instructions for the control unit belonging to it.
Model NDCC1000 NDCC1100 NDCC1200
Type Control unit for three-phase motors Control unit for inverter motors Control unit for single-phase motors
Power voltage 3~400Vac (+10% -10%) 50/60Hz 1~230Vac (+10% -10%) 50/60Hz 1~230Vac (+10% -10%) 50/60Hz
Motor max. power 2.2kW 2.2kW 2.2kW
Consumption in standby <5W
Power board fuses F1,F2,F3: 6.3A Type T F1,F2,F3: 10A Type T F1,F2,F3: 6.3A Type T
Logic board safety fuse F4: 1A Type F
Logic power voltage 24Vdc (with secondary protection F4)
Output 1 (Relay 1) Dry contact, programmable in parameter P112
Output 2 (Relay 2) Dry contact, programmable in parameter P111
Output 3 (Relay 3) Dry contact, programmable in parameter P110
Services output 24Vdc (max. 800mA, resistive load) on connector X5 - J30 with removable terminal
Safety edge
Resistive or pneumatic safety edge (selecting via “8k2” jumper) or OSE optical safety edge (selecting via "Opto” jumper),
programmable in parameter P105
UP input For normally open contacts (NO), programmable in parameter P100
DOWN input For normally open contacts (NO), programmable in parameter P101
IMP input For normally open contacts (NO), programmable in parameter P102
STOP input For normally closed contacts (NC), safety circuit
PRE LIMIT input For normally open contacts (NO), programmable in parameter P103
Photo input For normally closed contacts (NC), programmable in parameter P104
Radio connection SM connector for compatible Nice receivers (Options programmable in parameter P106)
Radio aerial input 52 ohm for RG58 cable or similar (max. 10m)
Programmable functions Functions programmable in programming mode with compatible interfaces
Operating temperature (-20 °C ÷ 50 °C)
Use in particularly acidic,
saline or potentially explosive
atmospheres
No
Protection rating IP65
Vibration Swing-free mounting (e.g. on a masonry wall)
Dimensions 310 x 210 x 125 mm
Weight 3.5 kg
To Next Page
Loading...
