Nice D-PRO AUTOMATIC NDCC1000 - General Safety Instructions; Work Safely

EN
4 – English
GENERAL SAFETY INSTRUCTIONS
The design and construction of the devices con-
tained in the D-PRO Automatic door control units,
as well as the information given in these use in-
structions, comply with the applicable safety reg-
ulations. Incorrect installation can result in serious
injury to persons carrying out the work or using the
system. For this reason, it is important to comply
fully with these instructions during installation.
Do not continue with the installation if you
have any doubts whatsoever and, if neces-
sary, request Nice customer service support.
Throughout this manual, the term "product" re-
fers to the D-PRO Automatic control unit mod.
NDCC1000 mod. NDCC1100, mod. NDCC1200.
Unless specied otherwise, the instructions apply
to all models.
WORK SAFELY!
WARNING! – Important safety instructions.
Failure to comply with safety regulations or
any installation, use or maintenance other
than those indicated in this booklet:
• Invalidates the warranty
• Can cause damage, injury or fatal accidents
• Relieves the Manufacturer from any liability.
WARNING! – Unauthorised work, tampering
or modications not in accordance with this
manual may result in damage, injury or fatal
accidents and will invalidate the warranty.
WARNING! – Store this manual carefully for
future reference.
WARNING! – Before performing any opera-
tion or procedure, carefully read the general
safety instructions given in this manual and
sect. "2.3 Product use limitations" on p. 6.
These instructions must be followed:
• Before starting the installation, check the tech-
nical specications of the product (see chap.
"7. PRODUCT SPECIFICATIONS" on p. 30),
in particular whether this product is suitable for
automating your guided part. If it is not suitable,
DO NOT proceed with the installation
• The product may not be used until it has been
put into service (see chap. "4. TESTING AND
PUTTING INTO SERVICE" on p. 30).
• During installation and maintenance oper-
ations, use the personal protective equip-
ment (PPE) required by the safety regu-
lations in force in the country where the
product is installed (e.g. protective gloves).
WARNING! – According to the most recent
European legislation, the installation of an au-
tomation must comply with the harmonised
standards set out in the current Machinery
Regulation, which enable the conformity of
the automation to be declared.
In view of this, all connection to the mains,
testing and putting into service, and mainte-
nance work must be carried out solely by a
competent, qualied technician!
• Before proceeding with product installation,
check that all the material to be used is in ex-
cellent condition and suitable for use
• The product is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
or knowledge
• Children must not play with the product
• Do not allow children to play with the product
control devices. Keep remote controls away
from children
WARNING! – To avoid any risk arising from
accidentally rearming the thermal cut-off de-
vice, this product must not be powered by an
external manoeuvre device, such as a timer,
or be connected to a circuit that is regularly
energized or de-energized.
• Provide a disconnection device (not supplied)
in the system's power supply network with a
contact opening distance that allows complete
disconnection under the conditions dictated by
overvoltage category III
• During the installation, handle the product care-
fully, avoiding crushing, knocks, falls or contact
with liquids of any kind. Do not put the prod-
uct near sources of heat or expose it to open
ames. All these actions can damage it and
cause malfunctions or dangerous situations. If
this happens, stop the installation immediately
and contact the Support Service
• The manufacturer accepts no liability for dam-
age to property or persons resulting from failure
to follow the assembly instructions. Warranty
for material defects is excluded in these cases
• The sound pressure level of the A-weighted
emission is less than 70 dB(A)
• Cleaning and maintenance intended to be car-
ried out by the user must not be carried out by
unsupervised children