Nice HO7124

ENGLISH – 29
TECHNICAL SPECIFICATIONS
12
12 TECHNICAL SPECIFICATIONS
l
All technical specications stated in this section refer to an ambient temperature of 20°C (± 5°C). Nice S.p.A.
reserves the right to apply modications to the product at any time when deemed necessary, without altering
its functions and intended use.
Table 13
TECHNICAL SPECIFICATIONS
Description Technical specication
HO7124 HO7224
Product type
Electromechanical gearmaotor for
automatic gate and door systems with
direct-current motor, epicyclic gear
reducer and mechanical unlocking
mechanism.
Incorporated control unit and OXI radio
receiver.
Electromechanical gearmaotor for
automatic gate and door systems with
direct-current motor, epicyclic gear
reducer and mechanical unlocking
mechanism.
Peak torque [corresponding to the ability to
develop a force capable of moving the leaf]
250 Nm
Nominal torque [corresponding to the ability
to develop a force capable of keeping the
leaf moving]
100 Nm
Nominal torque speed
0,13 rad/s (1,2 rpm)
No-load speed (the control unit allow for
programming 6 speeds roughly equal to:
100, 85, 70, 55, 45, 30%)
0,17 rad/s (1,6 rpm)
Maximum frequency of operating cycles (at
nominal torque)*
35 cycles/hour
Maximum continuous operating time (at
nominal torque)**
10 minutes
Application limits
The product can be used on gates with leaves weighing up to 250 kg for lengths up
to 1,5 m and with weight up to 160 kg for lengths up to 2,4 m
Durability
Estimated between 80,000 and 250,000 cycles, depending on the conditions
specied in the “Product durability” paragraph.
Power supply HOPP
230Va (120Va for version HO7124/V1)
(±10%) 50/60 Hz
24Vc (±25%)
Emergency power supply
With optional accessory PS124 -
Solar panel power supply
Conguration for SYKCE kit -
Maximum power draw at nominal torque
170W 50W
Peak power
280W 100W
Nominal current draw
0,8 A (1,6 A for version HO7124/V1) 2 A
Maximum current draw
1,3 A (2,6 A for version HO7124/V1) 4 A (for maximum 1 s)
Power draw in “Stand-by-All” mode with
power supply from PS124 or SYKCE kit
(including OXI receiver)
Below 100 mW -
Warning light output***
One ELB (lamp 12 Vc, 21 W) or ELDC
warning light
-
Electric lock output*** One 12 Va max 15 VA electric lock
-
BLUEBUS output
One output with maximum load of 12
Bluebus units
(maximum 6 pairs of EPM photocells plus
2 pairs of EPM photocells addressed as
opening devices plus maximum 4 EDSB
or ETPB control devices)
-
STOP input
For normally closed or normally open
contacts or for 8.2 kΩ xed resistor
contacts with self-learning (any variation
from the memorised status triggers the
STOP command)
-
Sbs input
For normally open contacts (closing of
the contact triggers the STEP-BY-STEP
command)
-
OPEN input
For normally open contacts (closing of
the contact triggers the PARTIAL OPEN 1
command)
-