EasyManuals Logo

Nice POA1 Instructions And Warnings For The Fitter

Nice POA1
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
GB
x3
x5
FLOR VERY VR FLO VERY VE SMILO
Buttons 1 – 2 - 4 2 1 – 2 - 4 2 2 - 4
Power input 12Vdc Batt. 23A 6Vdc lithium batt. 12Vdc Batt. 23° 6Vdc lithium batt. 12Vdc Batt. 23A
Absorption 10mA 10mA 15mA 10mA 25mA
Frequency 433.92MHz
Working temp. -40°C ÷ + 85°C
Radiated power 100µW
Deleting all transmitters
All the memorised codes can be deleted as follows:
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off
and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.
Receivers
Transmitters
Table “B4” Deleting all transmitters Example
RX
RX
SMXI SMXIS SMXIF
Decoding Rolling code Rolling code 1024 FLO combinations
52 bit FLOR 64 bit SMILO
Transmitter compatibility FLOR, VERY VR SMILO FLO, VERY VE
Frequency 433.92MHz
Input impedance 52ohm
Outputs 4 (on connector SMXI)
Sensitivity better than 0.5µV
Working temp. -10°C ÷ + 55°CC
Technical characteristics

Table of Contents

Other manuals for Nice POA1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nice POA1 and is the answer not in the manual?

Nice POA1 Specifications

General IconGeneral
BrandNice
ModelPOA1
CategoryControl Unit
LanguageEnglish

Related product manuals