Nikon D3 VBA18001 User Manual

- Ａ 30 ･ -
VBA18001-R.3719.A
logo�Q0440�forGraphic
070518�Gdesign�ito
Adjustments on PC required when parts are replaced
Camera body (other than Imaging-related)
Writing of
xed value
AE CCD
positioning
AE
accuracy
Aperture
accuracy
Shutter
M1/8000
Shutter
Monitor
AE sensor
inspection &
adjustment
AF
accuracy
Shutter unit
○ ○
Main PCB
○ △ ○ ○ ○ ○ ○ ○
AF sensor unit
○
DC/DC1
DC/DC2
Metering FPC unit
○ ○ ○
I base plate
○
＊
1
＊
2
＊
3
＊
1: Whenever the main PCB is replaced,
update the rmware after "writing of xed value", and then perform "writing
of xed value" again.
＊
2: Make the inspection.
＊
3: Whenever "AE sensor inspection and adjustment" is made, assemble up to the stage of DG-PCB unit, and
make the inspection and adjustment via USB.
Caution when Parallax/SI adjustment is necessary:
First of all, perform "writing of fixed value", and make "Shutter M1/8000 adjustment" followed by "Shutter monitor
adjustment". And then, make "Parallax/SI adjustment" and perform "AE CCD positioning".
△
(Revision)
Ｍ
サービス
計画課
Feb.25.2008
Changed page
△× 3
＊
4:
In case of replacing the Main PCB and needing the adjustment of parallax/SI and CCD positioning, perform "writing
of fixed value", and make "Shutter M1/8000 adjustment" followed by "Shutter monitor adjustment". And then, make
"Parallax/SI adjustment" and perform "AE CCD positioning".
＊
4
△
(Addition)
＊
4
△
(Addition)
INC

Nikon D3 VBA18001 Specifications

General

Brand	Nikon
Model	D3 VBA18001
Category	Digital Camera
Language	English