Nikon Eclipse TI-TIRF-E - C-LU2 Two-Laser Unit, and C-LU3 Three-Laser Unit; Preparation

Chapter 5 Laser Unit
5.2 C-LU2 Two-laser Unit, and C-LU3 Three-laser Unit
1-103
5.2 C-LU2 Two-laser Unit, and C-LU3 Three-laser Unit
The setup procedures for two-laser unit and three-laser unit are given below.
1. Preparation
2. Laser installation
3. Laser rough adjustment
4. Final adjustment for transmitting Ar laser light through the optical fiber
5. Final adjustment for transmitting He-Ne laser and 405 nm laser light through the optical fiber
6. Attaching the sheet metal covers
5.2.1 Preparation
1
Checking accessories
Confirm that the following accessories have been provided:
• Cable (×1)
• Hexagonal head screws (×3)
• Harness bands (×6)
• Harness band retainers (×4)
• Label (×1)
• Black rings of sponge (×2)
2
Removing sheet metal covers
Remove the screws and detach the sheet metal covers.
Figure 5.2-1
ND filter
Side sheet
metal cove
r
Adjuste
r
Top sheet
metal cove
r
ND filter
Side sheet metal
cove
r
Adjuste
r
Top sheet metal
cove
r
C-LU2 two-laser unit C-LU3 three-laser unit