1-67
Preparations
2
2.1 Check Items and Tools
2.1.1 Required Items
Make sure you have all of the following items before starting.
• PC (complete set)
• PC-related devices
• Operating system
• Laser: Recommended laser (see Chapter 1, “System Configuration and Part Names”)
• Camera system (for TIRF and PAU image observation)
• Dichroic mirror (when the photo activation illuminator unit is used only.)
• One power cable
one cable for the four-laser module: 100 VAC area: 125 VAC 7 A or higher;
200 VAC area: 250 VAC 6 A or higher
one cable for the AOM controller: 100 VAC area: 125 VAC 7 A or higher;
200 VAC area: 250 VAC 6 A or higher
two cables for the laser PS rack: 100 VAC area: 125 VAC 7 A or higher;
200 VAC area: 250 VAC 6 A or higher, and
100 VAC area: 125 VAC 15 A or higher;
200 VAC area: 250 VAC 10 A or higher
CAUTION
Be sure to prepare power cables satisfying the ratings as specified above and complying with
the local safety standards. Extra care must be taken for the laser PS rack in particular, which
has a great current capacity.
To Next Page
Loading...
Need help?
General