Chapter 5 Laser Unit
5.4 LU4A Four-laser Module A
1-196
5.4.7 Removing the AOTF Driver Remote Controller
Figure 5.4-110
1. When all the adjustments have been made, press
the [ESC] key of the AOTF driver remote controller
once or twice to display “external mode” on the
screen.
2. Remove the AOTF driver remote controller. Laser
control by PC is now available.
Precautions:
• Laser control by PC is not available when the AOTF driver remote controller screen does not
display “external mode.” Make sure that the screen displays “external mode” before starting the
laser control.
This is the end of the laser adjustments.
To Next Page
Loading...
Need help?
General