Chapter 1 System Configurations and Part Names
1.3 Safety Labels and Openings
1-32
1.3.9 TI-LUSU Shutter Unit
For the TIRF illuminator unit or the motorized TIRF illuminator unit
When used in combination with two-laser or three-laser unit
Make sure that the labels are affixed in place.
(4) Safety standard label (10) TI-TIRF special label
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Cet appareil numérique de la classe A est confirme
à la norme NMB-003 du Canada.
This Class A digital apparatus complies with Canadian
ICES-003.
MADE IN JAPAN
Exclusive use for TI
-
TIRF system
Don't use this unit with other systems.
RS-232C LASER UNIT
TI-LUSU
INPUT
1A
POWER
SAFETY
COVER
CLOSE
BINO
CLOSE
12V
LASER SHUTTER
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Cet appareil numérique de la classe A est confirme
à la norme NMB-003 du Canada.
This Class A digital apparatus complies with Canadian
ICES-003.
MADE IN JAPAN
Exclusive use for TI
-
TIRF system
Don't use this unit with other systems.
Figure 1.3-9
(4)
(10)
(Bottom view)
(Top view)
To Next Page
Loading...
Need help?
General