Chapter 1 System Configurations and Part Names
1.3 Safety Labels and Openings
1-33
For the photo activation illuminator unit
When used in combination with two-laser or three-laser unit
Make sure that the labels are affixed in place.
(4) Safety standard label (10) TI-PAU special label
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Cet appareil numérique de la classe A est confirme
à la norme NMB-003 du Canada.
This Class A digital apparatus complies with Canadian
ICES-003.
MADE IN JAPAN
Exclusive use for TI
-
PAU system
Don't use this unit with other systems.
RS-232C LASER UNIT
TI-LUSU
INPUT
1A
POWER
SAFETY
COVER
CLOSE
BINO
CLOSE
12V
LASER SHUTTER
ON
OFF
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Cet appareil numérique de la classe A est confirme
à la norme NMB-003 du Canada.
This Class A digital apparatus complies with Canadian
ICES-003.
MADE IN JAPAN
Exclusive use for TI
-
PAU system
Don't use this unit with other systems.
Figure 1.3-10
(4)
(10)
(Bottom view)
(Top view)
To Next Page
Loading...
Need help?
General