Chapter 5 Laser Unit
5.3 C-LU3EX Three-laser Unit EX
1-151
Figure 5.3-70
2. Tighten the two clamp screws on the coupler, and
then tighten the rotation clamp screw.
3. Record the Ar laser brightness. (Note the power
meter wavelength setting.)
4. Open the other laser shutters and check that laser
light is emitted. If no light is emitted from the other
lasers, repeat the procedure of P.1-132, “Adjusting
the He-Ne laser and 405 cylindrical laser.”
To Next Page
Loading...